SET_CONNECTOR_MARKS

SET_CONNECTOR_MARKS turns the creation of connector marks on or off.

Syntax

CC "Modeling" SET_CONNECTOR_MARKS   [ id | modelid:id ] [ create:boolValue ] .
# --> RESULT ecode:intValue .

Parameters

idmodifier
modelidid
createboolValue

Returns

ecodeintValue, Contains the error code or is 0 in case of success.

Remarks

This command is useful where it shall be guaranteed that printing is performed with (resp. without) connector marks.  By now there is no corresponding read command, but the reading the connector marks status can therefore be done via the connector marks model attribute.

See Also

Example 1

# setting the creation of connector marks of the active model
CC "Modeling" SET_CONNECTOR_MARKS create    # "on"
CC "Modeling" SET_CONNECTOR_MARKS create:0  # "off"
CC "Modeling" SET_CONNECTOR_MARKS create:1  # "on"